Delete test directory

test/klippy/input_shaper.cfg

@@ -1,85 +0,0 @@
-# Test config for input_shaper
-[stepper_x]
-step_pin: PF0
-dir_pin: PF1
-enable_pin: !PD7
-microsteps: 16
-rotation_distance: 40
-endstop_pin: ^PE5
-position_endstop: 0
-position_max: 200
-homing_speed: 50
-
-[stepper_y]
-step_pin: PF6
-dir_pin: !PF7
-enable_pin: !PF2
-microsteps: 16
-rotation_distance: 40
-endstop_pin: ^PJ1
-position_endstop: 0
-position_max: 200
-homing_speed: 50
-
-[stepper_z]
-step_pin: PL3
-dir_pin: PL1
-enable_pin: !PK0
-microsteps: 16
-rotation_distance: 8
-endstop_pin: ^PD3
-position_endstop: 0.5
-position_max: 200
-
-[extruder]
-step_pin: PA4
-dir_pin: PA6
-enable_pin: !PA2
-microsteps: 16
-rotation_distance: 33.5
-nozzle_diameter: 0.500
-filament_diameter: 3.500
-heater_pin: PB4
-sensor_type: EPCOS 100K B57560G104F
-sensor_pin: PK5
-control: pid
-pid_Kp: 22.2
-pid_Ki: 1.08
-pid_Kd: 114
-min_temp: 0
-max_temp: 210
-
-[heater_bed]
-heater_pin: PH5
-sensor_type: EPCOS 100K B57560G104F
-sensor_pin: PK6
-control: watermark
-min_temp: 0
-max_temp: 110
-
-[mcu]
-serial: /dev/ttyACM0
-
-[printer]
-kinematics: cartesian
-max_velocity: 300
-max_accel: 3000
-max_z_velocity: 5
-max_z_accel: 100
-
-[input_shaper]
-shaper_type_x: mzv
-shaper_freq_x: 33.2
-shaper_type_x: ei
-shaper_freq_x: 39.3
-
-[adxl345]
-cs_pin: PK7
-axes_map: -x,-y,z
-
-[mpu9250 my_mpu]
-
-[resonance_tester]
-probe_points: 20,20,20
-accel_chip_x: adxl345
-accel_chip_y: mpu9250 my_mpu