klipper update

config/sample-probe-as-z-endstop.cfg

@@ -0,0 +1,46 @@
+# This file provides example config file settings for use on a printer
+# that uses a Z probe instead of a traditional Z endstop switch. This
+# file is just a "snippet" of config sections - it must be added to a
+# config file containing the configuration of the rest of the printer.
+
+# Be sure to review and update this config with the appropriate pins
+# and coordinates for your printer.
+
+# See docs/Config_Reference.md for a description of parameters.
+
+# Define a probe
+[probe]
+pin: ar30
+z_offset: 2.345
+
+# Example settings to add to stepper_z section
+[stepper_z]
+endstop_pin: probe:z_virtual_endstop
+position_min: -2 # The Z carriage may need to travel below the Z=0
+                 # homing point if the bed has a significant tilt.
+
+# The safe_z_home section modifies the default G28 behavior
+[safe_z_home]
+home_xy_position: 100, 100
+speed: 50
+z_hop: 15
+z_hop_speed: 5
+
+# Example bed_tilt config section
+[bed_tilt]
+points:
+    100, 100
+    10, 10
+    10, 100
+    10, 190
+    100, 10
+    100, 190
+    190, 10
+    190, 100
+    190, 190
+
+# Example bed_mesh config section
+[bed_mesh]
+mesh_min: 20, 20
+mesh_max: 200, 200
+probe_count: 4, 4