klipper update

config/printer-tronxy-x5s-2018.cfg

@@ -0,0 +1,96 @@
+# This file contains pin mappings for the Tronxy X5S (circa 2017). To
+# use this config, the firmware should be compiled for the AVR
+# atmega1284p.
+
+# Note, a number of Melzi boards are shipped with a bootloader that
+# requires the following command to flash the board:
+#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
+# If the above command does not work and "make flash" does not work
+# then one may need to flash a bootloader to the board - see the
+# Klipper docs/Bootloaders.md file for more information.
+
+# See docs/Config_Reference.md for a description of parameters.
+
+[stepper_x]
+step_pin: PD7
+dir_pin: !PC5
+enable_pin: !PD6
+microsteps: 16
+rotation_distance: 40
+endstop_pin: ^!PC2
+position_endstop: 0
+position_max: 330
+homing_speed: 50
+
+[stepper_y]
+step_pin: PC6
+dir_pin: !PC7
+enable_pin: !PD6
+microsteps: 16
+rotation_distance: 40
+endstop_pin: ^!PC3
+position_endstop: 0
+position_max: 310
+homing_speed: 50
+
+[stepper_z]
+step_pin: PB3
+dir_pin: PB2
+enable_pin: !PD6
+microsteps: 16
+rotation_distance: 8
+endstop_pin: ^!PC4
+position_endstop: 0.5
+position_max: 400
+
+[extruder]
+step_pin: PB1
+dir_pin: PB0
+enable_pin: !PD6
+microsteps: 16
+rotation_distance: 35.520
+nozzle_diameter: 0.400
+filament_diameter: 1.750
+heater_pin: PD5
+sensor_type: EPCOS 100K B57560G104F
+sensor_pin: PA7
+control: pid
+pid_Kp: 22.2
+pid_Ki: 1.08
+pid_Kd: 114
+min_temp: 0
+max_temp: 275
+
+[heater_bed]
+heater_pin: PD4
+sensor_type: EPCOS 100K B57560G104F
+sensor_pin: PA6
+control: watermark
+min_temp: 0
+max_temp: 150
+
+[verify_heater heater_bed]
+# adjust for personal bed setup, this prevents stock heated bed from issuing
+# false positive heating errors due to slow temperature increase
+check_gain_time: 600
+
+[fan]
+pin: PB4
+
+[mcu]
+serial: /dev/ttyUSB0
+
+[printer]
+kinematics: corexy
+max_velocity: 300
+max_accel: 1000
+max_z_velocity: 20
+max_z_accel: 100
+
+[display]
+lcd_type: st7920
+cs_pin: PA1
+sclk_pin: PC0
+sid_pin: PA3
+encoder_pins: ^PD2, ^PD3
+click_pin: ^!PA5