Initial commit

include/KlippyGcodes.h

@@ -0,0 +1,60 @@
+#ifndef KLIPPY_GCODES_H
+#define KILPPY_GCODES_H
+
+#include <iostream>
+
+#define AXIS_X "X"
+#define AXIS_Y "Y"
+#define AXIS_Z "Z"
+
+#define HOME "G28"
+#define HOME_X "G28 X"
+#define HOME_Y "G28 Y"
+#define HOME_Z "G28 Z"
+#define HOME_XY "G28 X Y"
+#define Z_TILT "Z_TILT_ADJUST"
+#define QUAD_GANTRY_LEVEL "QUAD_GANTRY_LEVEL"
+
+#define MOVE "G1"
+#define MOVE_ABSOLUTE "G90"
+#define MOVE_RELATIVE "G91"
+
+#define EXTRUDE_ABS "M82"
+#define EXTRUDE_REL "M83"
+
+#define SET_EXT_TEMP "M104"
+#define SET_BED_TEMP "M140"
+
+#define SET_EXT_FACTOR "M221"
+#define SET_FAN_SPEED "M106"
+#define SET_SPD_FACTOR "M220"
+
+#define PROBE_CALIBRATE "PROBE_CALIBRATE"
+#define Z_ENDSTOP_CALIBRATE "Z_ENDSTOP_CALIBRATE"
+#define TESTZ "TESTZ Z="
+#define ABORT "ABORT"
+#define ACCEPT "ACCEPT"
+
+#define SAVE_CONFIG "SAVE_CONFIG"
+#define RESTART "RESTART"
+#define FIRMWARE_RESTART = "FIRMWARE_RESTART"
+
+std::string set_bed_temp(int temp);
+std::string set_ext_temp(int temp, int tool);
+std::string set_heater_temp(std::string heater, int temp);
+std::string set_temp_fan_temp(std::string temp_fan, int temp);
+std::string set_fan_speed(int speed);
+
+std::string set_fan0_speed(int speed);
+std::string set_fan2_speed(int speed);
+std::string set_fan3_speed(int speed);
+
+std::string set_extrusion_rate(std::string rate);
+std::string set_speed_rate(std::string rate);
+std::string testz_move(std::string dist);
+std::string extrude(std::string dist, int speed);
+std::string bed_mesh_load(std::string profile);
+std::string bed_mesh_remove(std::string profile);
+std::string bed_mesh_save(std::string profile);
+
+#endif