update

tests/data/fff_print_tests/test_gcodewriter/config_lift_unlift.ini

@@ -0,0 +1,30 @@
+before_layer_gcode = 
+between_objects_gcode = 
+end_filament_gcode = "; Filament-specific end gcode \n;END gcode for filament\n"
+end_gcode = M104 S0 ; turn off temperature\nG28 X0  ; home X axis\nM84     ; disable motors\n
+extrusion_axis = E
+extrusion_multiplier = 1
+filament_cost = 0
+filament_density = 0
+filament_diameter = 3
+filament_max_volumetric_speed = 0
+gcode_comments = 0
+gcode_flavor = reprap
+layer_gcode = 
+max_print_speed = 80
+max_volumetric_speed = 0
+retract_length = 2
+retract_length_toolchange = 10
+retract_lift = 1.5
+retract_lift_above = 0
+retract_lift_below = 0
+retract_restart_extra = 0
+retract_restart_extra_toolchange = 0
+retract_speed = 40
+start_filament_gcode = "; Filament gcode\n"
+start_gcode = G28 ; home all axes\nG1 Z5 F5000 ; lift nozzle\n
+toolchange_gcode = 
+travel_speed = 130
+use_firmware_retraction = 0
+use_relative_e_distances = 0
+use_volumetric_e = 0